Reproduction Parts for 1916-1964 Chevrolet Passenger Cars & 1918-1987 Chevrolet & GMC Trucks



Visit the new site at vcca.org

Previous Thread
Next Thread
Print Thread
Rate Thread
Joined: Oct 2021
Posts: 1
Brookj Offline OP
Grease Monkey
OP Offline
Grease Monkey
Joined: Oct 2021
Posts: 1
Will a 1966 impala 12 bolt fit a 1966 chevelle with no altering?

Wilwood Engineering1955-1957

Willwood Engineering

Wilwood Engineering designs and manufactures high-performance disc brake systems.
Wilwood Engineering, Inc. - 4700 Calle Bolero - Camarillo, CA 93012 - (805) 388-1188


Joined: May 2002
Posts: 6,149
Likes: 42
ChatMaster - 6,000
Offline
ChatMaster - 6,000
Joined: May 2002
Posts: 6,149
Likes: 42
Welcome to Chatter
The 1966 and Chevelle models are a bit later than my knowledge if they are both leaf spring the 1st problem is spring seat position or if 1 is coil and 1 leaf spring you have another problem. As I think the Impala is a wider car so therefore use a wider axle housing and spring mount position. Take a suitable length measuring device and lots of photos to compare the 2 before putting either vehicle in the unmovable situation.
Tony


1938 1/2 ton Hope to drive it before I retire
Joined: Jul 2005
Posts: 3,192
Likes: 8
ChatMaster - 3,000
Offline
ChatMaster - 3,000
Joined: Jul 2005
Posts: 3,192
Likes: 8
No, an Impala 12 bolt will not fit a chevelle, both have coil spring rear suspension, but the arms are completely different locations and angles.

Last edited by jack39rdstr; 10/11/21 03:47 AM.

JACK

Link Copied to Clipboard
 

Notice: Any comments posted herein do not necessarily reflect the official position of the VCCA.

Powered by UBB.threads™ PHP Forum Software 7.7.5