Hello Everyone,

I am helping a friend fix up a 1953 Chevy 1/2 ton pick-up truck. We have pulled the rear end apart to fix a few leaks. Being that far into it he wants to replace the Oakie bushing, which he purchased from CoF's.

I read the instructions and checked out a couple of videos. One video that caught my attention had to do with the new bushing not going in. Fortunately the gentleman had removed the original and measured the outside diameter, then measured the new one and found the new one to be oversized just enough that it would not go in. He brought it to work and turned it down to the orginals dimensions.

So I am asking if someone has the removal tool that I could borrow or rent to complete this project.

Last edited by dfd37chev; 04/27/23 10:05 PM.

Dave
old cars are meant to be driven !!
VCCA # 047832