|
|
Joined: Sep 2012
Posts: 13
Grease Monkey
|
OP
Grease Monkey
Joined: Sep 2012
Posts: 13 |
Hello everyone, I have a 47 Chevy with a 261cui, 90amp Powergen 12V alternator and 12V battery. My ammeter gauge is not reading anything. Is this because I'm running a 12V? Or is it because I'm running an alternator? Thanks in advance.
|
|
|
|
Joined: Jan 2002
Posts: 30,700 Likes: 141
ChatMaster - 25,000
|
ChatMaster - 25,000
Joined: Jan 2002
Posts: 30,700 Likes: 141 |
Because of the alternator. An ammeter will not work with an AC alternator.
Gene Schneider
|
|
|
|
Joined: Sep 2002
Posts: 2,323 Likes: 6
ChatMaster - 2,000
|
ChatMaster - 2,000
Joined: Sep 2002
Posts: 2,323 Likes: 6 |
Most of the time the ammeter is bypassed when converting to an alternator. That is because the alternator can put out more current than the ammeter can handle. I recently purchase a non Chevrolet car that had been converted to an alternator. I wanted information on the health of the system while operating the car. I purchased a charge monitor from an Ebay vendor in the UK. It is a tiny LED display that changes color for different voltages. So with the car not running, turning on the ignition causes it to display green, if the voltage is 11.8 or above. It will show yellow below that and red if it gets further down. If the charging voltage gets too high, it will flash.
My 1951 1 Ton is now on the road! My 38 Master 4 Door is also now on the road .
|
|
|
|
Joined: Sep 2012
Posts: 13
Grease Monkey
|
OP
Grease Monkey
Joined: Sep 2012
Posts: 13 |
Thanks for the replies. There's an article on the Stovebolt where someone swapped out the ammeter with a voltmeter; he took the original ammeter face and replaced the modern voltage gauge face. Looked sharp!
|
|
|
0 members (),
74
guests, and
8
robots. |
Key:
Admin,
Global Mod,
Mod
|
|
Forums58
Topics59,072
Posts429,077
Members18,308
|
Most Online1,133 Jan 22nd, 2020
|
|
|
|
|