Reproduction Parts for 1916-1964 Chevrolet Passenger Cars & 1918-1987 Chevrolet & GMC Trucks



Visit the new site at vcca.org

Previous Thread
Next Thread
Print Thread
Rate Thread
#235011 02/21/12 05:53 PM
Joined: Dec 2010
Posts: 680
Oil Can Mechanic
OP Offline
Oil Can Mechanic
Joined: Dec 2010
Posts: 680
The weather has been so nice on Long Island that I pulled the 31 from storage a little earlier than planned. To my joy it started up after cranking a bit and ran relatively well. I'd done a valve job just before putting her away and have not tweaked everything to my liking. I need to pull the transmission, bellhousing and clutch for inspection. Second gear has a missing tooth and luckily I have another tranny from a 31 parts car. also, I am installing a Hamptons interior purchased last year. I'll set up a 4X8 work table to aid with layout and fabrication for the interior. Thanks for reading this and suggestions are requested as always. Al W.


It's Wise to choose a six!
Filling Station - Chevrolet & GMC Reproduction Parts


Filling Station


Joined: Aug 2003
Posts: 720
Oil Can Mechanic
Offline
Oil Can Mechanic
Joined: Aug 2003
Posts: 720
you need to get the kit out of the boxes and stretch the material especially the headliner . makes the instalion easier . hope this helps

Joined: Dec 2010
Posts: 680
Oil Can Mechanic
OP Offline
Oil Can Mechanic
Joined: Dec 2010
Posts: 680
Great idea! I'll follow your idea! A sunny, warm day for the install probably makes sense.


It's Wise to choose a six!

Link Copied to Clipboard
 

Notice: Any comments posted herein do not necessarily reflect the official position of the VCCA.

Powered by UBB.threads™ PHP Forum Software 7.7.5